BMW R75/6 as-bought. Mint, except:

front wheel rim bent

missing caliper, master cylinder and hydraulic line

bad front wheel bearing

bent fork tubes

bent handlebar

broken mirrors

broken clutch switch

mismatched and torn rubber grips and foot peg rubbers

missing steering damper cylinder

demolished instrument cluster

throttle, brake, clutch, tach, speedometer cables shot

improvised headlight: 35W sealed beam instead of 60W halogen bulb

turn signal relay had cracked circuit board trace

rotted regulator

starter relay points filed so far that armature hit stop before points made firm contact

battery box bent; most of its rubber mounts broken, no battery

battery cables had twisted splices wrapped with black tape

no horn

broken toolbox, no tools

gas tank dented, gas tank rear shock mounts broken, petcock filters broken

seat hinges broken or missing

seat cover torn and duct taped

seat pan rusty and cracked - needed sandblasting, welding, and painting

motor removed from bike; cylinders, heads, valve gear, front cover, engine electricals, timing
cover all removed and piled in metal buckets

transmission front seal leaking

seller advised that "some part or tool" had fallen into the motor - this turned out to be a short piece	of metal rod wedged into the bottom of the threaded hole on the nose of the crankshaft.
(Previous owner had used a stack of scrap hardware instead of a single rod rotor removal
tool).

rings worn

several needles lost from one rocker arm bearing while motor was apart

valve covers cracked

one fin cracked at top of one cylinder head

all oil seals, carburetor O-rings, and other rubber parts brittle

oil filter O-ring swimming around in sump

ignition points had been filed to the point that they could no longer be gapped to spec

improvised substitute capacitor

rear sub-frame bent, rear shocks shot

mufflers shot

19" tube in the 18" rear tire

tires worn and rock hard

Difficulties

pulling timing chain sprocket from crank

removing bolts holding front main bearing carrier

removing needle bearing shell from rocker arm

installing needle bearing shell in rocket arm

learning to change tires