#  chirp cw.. 
# siggen 1 chn 1 sweep
# siggen 2 chn 1 burst 
# chirp chop for paul. using siggen 1 output with siggen 2 arb from chn 1
# to set:
# freq1,2  to sweep between
# swptime:
# need to setup the arb waveform .. h5msl5ms  .. and chirpchop.seq to match swptime + off time:
# eg  swptime 5ms
#     h1msl4ms
# sg2 triggered by 1 sec tick
set srate 1000
set freq1 "5.095e6"
set freq2 "5.125e6"
set swptime ".005"
set burstfrq 399.1
#set bcnt "399"
set bcnt "199"
set pulsew ".001"
set outampSin "4.3dbm"
set sgSin    1
set chnSin    1
set sgBurst  2
set chnBurst  1
set sgArb  3
set chnArb  1
log -->start 20on,10off with chirp
arb $sgArb $chnArb clr

config $sgBurst burst1.cfg pulsew=$pulsew,freq=$burstfrq,bcnt=$bcnt
config $sgSin chirpcw.cfg freq1=$freq1,freq2=$freq2,outamp=$outampSin,swptime=$swptime
#                 xxxxxxxxxxxx
arb $sgArb $chnArb load arbstart      L40
arb $sgArb $chnArb load h1m           H60000
arb $sgArb $chnArb load l1m           L60000
#
send $sgArb SOURCE1:FUNC ARB
#
arb $sgArb $chnArb seq h3252/onoff2010.seq
send $sgArb SOURCE1:FUNC:ARB onoff2010
config $sgArb arb1_only.cfg srate=$srate,seqnm=onoff2010

startsg $sgSin 1 sine  -1
syncsec .9
startsg $sgBurst $chnBurst  burst 1000
startsg $sgArb   $chnArb     seq:onoff2010 3600